PARAMETERS MANUFACTURE DOUBLE SIDE
| CLASS 3 | CLASS 4 | CLASS 5 | CLASS 6 | CLASS 7 | ||
| Minimum plated through hole diameter | 
|
0,50 mm | 0,30 mm | 0,30 mm | 0,20 mm | 0,15 mm |
| Minimum non plated through hole diameter | 
|
0,60 mm | 0,40 mm | 0,40 mm | 0,30 mm | 0,25 mm |
| Aspect / Ratio | 
|
5 | 5 | 6 | 8 | 13
(maximum thickness 2 mm) |
| Minimum trace / spacing width (base copper thickness) | 
|
0,300 mm (17 µ)
0,300 mm (35 µ) 0,350 mm (70 µ) 0,350mm (105µ) |
0,200 mm (17 µ)
0,200 mm (35 µ) 0,250 mm (70 µ) 0,300mm (105µ) |
0,150 mm (17 µ)
0,150 mm (35 µ) 0,200 mm (70 µ) 0,250 mm (105 µ) |
0,125 mm (17 µ)
0,150 mm (35 µ) 0,175 mm (70 µ) 0,200 mm (105 µ) |
0,100 mm (17 µ)
|
| Minimum annular ring
|
|
0.22 mm | 0.17 mm | 0.13mm | 0.10mm | 0.075 mm |
Last update: 28-04-2023 Units: Milimeters |